THE ALL NEW DIGITAL

STAR-TRAC I -- SEMI-AUTOMATIC

	Used by metal fabricators to achieve a machine - like "U" or "J" groove in light or heavy plate, flat or round.
	Grooves, bevels, gouges or cuts any kind of metal quickly and at a low cost.
	Produces a higher quality finish than grinding, chipping or older methods of plate preparation.
	Speeds up metal fabrication by preparing both plates at the same time.
	Requirements: Current from a standard welding power source Symex jointed gouging electrodes A minimum of 80 psi of compressed air
	Current and air fed to torch through a special concentric Symex cable with an on/off switch.
	Equipped to work with 3/8", 1/2" and 5/8" Symex "Secur-Fit" jointed electrodes. These special blend electrodes assure superior arc stability and economy.
	Equipped with one of three different shoe caps, each accepting only one electrode size.

STAR-TRAC II -- AUTOMATIC

	Designed for continuous gouging of long seams in the manufacturing of ships, pressure vessel tanks, bridges, etc.
	High resolution voltage control capability regulates accurate gouging depth to a machine-like tolerance of ± 0.015" (0.4mm) even over a warped plate.
	Can be mounted on a travel system such as a Gullco unit or similar equipment with a holding capacity of at least 29 lbs. (13.15kg).
	Total weight of system less travel equipment (carriage and track) is 29 lbs.
	Equipped to work with 5/16", 3/8", 1/2" and 5/8" Symex jointed "Secur-Fit" gouging electrodes up to 1200 amps.
	Ideally suited for out-of-position work due to its light weight.
	Input voltage of the control unit is: Single phase: AC 115V 50/60HZ 100W
	Also Available in AC 230V.